1. <rt id="addey"></rt>
    2. <ruby id="addey"></ruby>
      <rt id="addey"></rt>
        <rp id="addey"></rp>
        1. <b id="addey"><form id="addey"></form></b>
          <b id="addey"><form id="addey"></form></b>
        2. <rp id="addey"></rp>

        3. 歡迎來到山東途暢路橋工程有限公司官網!

          logo

          1. 專注強夯機租賃,液壓沖擊夯租賃、強夯工程施工碎石樁等
          2. 地基軟基處理于一體的高質量基礎工程施工公司

          全國施工租賃熱線

          18264104888

          強夯機要定期更換各處減速機的齒輪油

          網址:http://www.xuanhuataobao.com/   發布日期:2022-09-30 關注次數:
          強夯機的大量和大負荷工作使其常常出現這樣那樣的故障,定期的維護和保養可以避免一些故障的發生,強夯機租賃廠家建議:要定期更換各處減速機的齒輪油。下面分析下:
          The massive and heavy load work of the dynamic compactor makes it often have failures of one kind or another. Regular maintenance and servicing can avoid some failures. The dynamic compactor rental manufacturer suggests that the gear oil of the reducers at various places should be replaced regularly. The following analysis:
          一:(主卷揚)提升減速機油量檢查和換油
          1: (Main winch) inspection and oil change of lifting reducer
          初次換油在150小時后,以后每隔500小時進行一次。檢查主卷揚減速機油量的位置在側面是一個螺塞的堵頭。換油時,先將滾筒上鋼絲繩放得露出加油孔和放油孔,然后將減速機卷筒正下方的放油塞卸下,然后再卸下正上方的螺塞,進行排氣,即可正常排油。然后將放油塞安裝好,再將約6到7升CL-585W/90重負荷車輛齒輪油從加油口注入,將加油塞安裝好。
          The first oil change shall be carried out every 500 hours after 150 hours. The position for checking the oil volume of the main winch reducer is the plug of a screw plug on the side. When changing the oil, first place the steel wire rope on the drum to expose the oil filling hole and oil drain hole, then remove the oil drain plug directly below the reducer drum, and then remove the plug plug directly above the reducer drum for air exhaust, so that the oil can be drained normally. Then install the oil drain plug, and inject about 6-7L CL-585W/90 heavy load vehicle gear oil from the oil filler, and then install the oil filler plug.
          二:行走減速機油量檢查和換油初次換油在150小時后進行,以后每隔1500小時進行一次。加注方法:旋轉減速機使得油塞處于水平和下方。然后將下方油塞卸下,再卸下水平位置的放油塞,即可排油。然后旋轉減速減使得油塞處于水平和正上方。然后從正上方油塞倒入約8到9升CL-585W/90重負荷車輛齒輪油,當水平方向油塞漏出齒輪油后,將水平油塞安裝好。再往里加入半升齒輪油即可
          2: The oil volume inspection and the first oil change of the traveling reducer shall be conducted 150 hours later and every 1500 hours thereafter. Filling method: rotate the reducer to make the oil plug horizontal and lower. Then remove the lower oil plug, and then remove the oil drain plug at the horizontal position to drain the oil. Then rotate the decelerator so that the oil plug is level and above. Then pour about 8 to 9 liters of CL-585W/90 heavy-duty vehicle gear oil from the oil plug directly above. When the gear oil leaks from the horizontal oil plug, install the horizontal oil plug. Add half a liter of gear oil
          強夯機租賃
          三:變幅減速機油量檢查和換油
          3: Inspection and oil change of luffing reducer
          換油每隔1500小時進行一次。先將通氣塞、加油塞卸下,再卸下放油塞,即可排油。然后將放油塞安裝好,將約3升CL-585W/90重負荷車輛齒輪油從加油口注入,將加油塞和通氣塞安裝好。當減速機儲存期限超出12個月時,須進行專門的檢查和防銹處理。
          Change the oil every 1500 hours. First remove the vent plug and filler plug, and then remove the drain plug to drain the oil. Then install the oil drain plug, inject about 3L CL-585W/90 heavy load vehicle gear oil from the oil filler, and install the oil filler plug and vent plug. When the storage life of the reducer exceeds 12 months, special inspection and anti rust treatment must be carried out.
          四:回轉減速機油量檢查和換油
          4: Oil quantity inspection and oil change of slewing reducer
          換油初次150小時進行,以后每隔1500小時進行一次。先將減速機上的加油通氣口螺塞卸下,再將放油口的放油塞卸下,即可排油。油排干凈后,先將放油塞安裝好,將6升18號雙曲線齒輪油從加油口內加入,油加至加油油位口50-35毫米深度為止,將加油塞安裝好。
          The oil shall be changed for 150 hours for the first time and every 1500 hours thereafter. Remove the oil filler plug on the reducer first, and then remove the oil drain plug at the oil drain port to drain the oil. After the oil is drained, first install the oil drain plug, add 6 liters of No. 18 hyperbolic gear oil from the oil filler, and fill the oil to the depth of 50-35 mm from the oil filler oil level port, and then install the oil filler plug.
          減速機的工作壽命可通過適當的維護與保養措施而得到相當大的提高。每日都要進行目視檢查,特別第檢查減速機的密封性。定期檢查減速機的異常噪音。定期檢查減速機的油位。
          The working life of the reducer can be greatly improved through proper maintenance and repair measures. Visual inspection shall be carried out every day, especially the sealing of the reducer. Regularly check the reducer for abnormal noise. Check the oil level of the reducer regularly.
          液壓油的選用和更換:根據環境溫度選用液壓油,若環境溫度較低時應采用粘度較低的液壓油,反之,要采用粘度較高的液壓油,每次換油時,應仔細清洗油箱和過濾器,加油時應通過加油濾網注入。更多相關的注意事項就來我們網站http://www.xuanhuataobao.com進行咨詢吧!
          Selection and replacement of hydraulic oil: The hydraulic oil shall be selected according to the ambient temperature. If the ambient temperature is low, the hydraulic oil with low viscosity shall be used. On the contrary, the hydraulic oil with high viscosity shall be used. Each time the oil is changed, the oil tank and filter shall be carefully cleaned, and the oil shall be injected through the filler screen. More relevant precautions come to our website http://www.xuanhuataobao.com Consult!
        4. 標簽:
        5. 韩国A片在线观看全免费
            1. <rt id="addey"></rt>
            2. <ruby id="addey"></ruby>
              <rt id="addey"></rt>
                <rp id="addey"></rp>
                1. <b id="addey"><form id="addey"></form></b>
                  <b id="addey"><form id="addey"></form></b>
                2. <rp id="addey"></rp>